Dendroboard banner

1 - 4 of 4 Posts

·
Registered
Joined
·
301 Posts
Discussion Starter #1
I am ready to install my new mistking system,I cannot remove the other end,I have the tool that came with it.They are just not comeing apart.
 

·
Registered
Joined
·
874 Posts
If you are talking about the part that goes into the top of the mist head.. to separate.. you must push the inner tab down while pulling apart at the same time.. it has a barb wire locking mechanism.
 

·
Registered
Joined
·
30 Posts
Can I use this same thread to ask a similar question: I was trying to clean my mistking nozzle heads..I have the premium fittings and It was impossible to open the nozzle heads from the nozzles. Is there a trick to it? I don't want to break them.
 
1 - 4 of 4 Posts
Top