Nice Viv!I thought I would share here. I have been lurking for a long while, and recently added a Mist King system to my Auratus Vivarium and I needed a way to mount the nozzles and tubing. I wasn't quite sure how I wanted to mount it, so I modeled up some magnetic mounts in Fusion 360 and printed them on my 3d printer.
I was really happy with how everything worked out, and the magnets are strong enough that I think I might end up just leaving everything connected/mounted magnetically. I used some 25x5x3 magnets superglued into each side. These are the actual magnets I ordered on Amazon: https://www.amazon.com/dp/B09YCWKBMP
I might swap them out for a larger, 25x25mm magnet at some point, but honestly the bond is strong enough through both the Exo-Terra screen and a thin piece of lexan, that I am not sure if I will re-model them for a larger magnet.
I've included a couple photos of the setup, and a couple of my juvenile Auratus just because.
I uploaded the models here, on Printables: Printables
View attachment 313985
View attachment 313986
View attachment 313984
View attachment 313983
View attachment 313982