Dendroboard banner

1 - 7 of 7 Posts

·
Registered
Joined
·
791 Posts
Discussion Starter · #1 ·
How might I close a one inch gap between a top vent and the glass door? (short of getting another piece of glass cut...)
 

·
Registered
Joined
·
31 Posts
Are you describing an aquarium set up vertically? If so, a piece of acrylic can be attached to the vent from the back, but the latch will need to be redone to hold the glass door closed.
Do you have a picture? That would make it easier to make a recommendation.
 

·
Registered
Joined
·
294 Posts
Go to Hobby Lobby. Buy a piece of "quilting template plastic". Cut out what you need and attach with clear plastic packaging tape! Done!
 

·
Registered
Joined
·
791 Posts
Discussion Starter · #6 ·
I'm just getting new glass cut. It's a big pain but I would rather have it over with now rather than even bigger problems later...
 
1 - 7 of 7 Posts
Top