Dendroboard banner
1 - 12 of 12 Posts
G

·
Discussion Starter · #1 ·
Does anyone have a drainage schematic? I have a wire rack that I am putting 4 vertical 10 gallon tanks with misting heads and a drain. Under that will be two rows of 3 x 16" cubes. Any suggestions would be appreciated.

Also, does anyone know where online to get 1/2" bulkheads for drains? Apparently, MD, VA, DC does not carry such a thing or know what they are!!! Should I get threaded or slip?

Thanks,
n
 

· Registered
Joined
·
1,233 Posts
Marinedepot.com has them. If there is a good saltwater fish store near you they should have some. You can also try any boating store near you, they usually have them also.

Threaded is probably better, since it has a strong seal, but make sure to use teflon tape also.
 

· Registered
Joined
·
792 Posts
I just received 8 from fishsupply.com (mentioned a few posts above) the other day. I only need 4 right now, and could sell you one or two at price. These are 1/2" bulkheads. I could deliver at the next MAD meeting.

Josh
 
G

·
Discussion Starter · #10 ·
BulkHeads

Hi my name is Rich.
I was reading all the post on bulkheads and i also found them on the fish
Site on the above post , i have a question after you put the bulkhead in do you buy a pice for the hose to go over or put a vale on it so you can drain when it get high, and do you put silicone on the bulkhead?.
Any help would be grate.


Thanks and have a grate day.

Rich. :D
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top