[wesly2007]

so i got a 30 hex and after gettimg the hard water spots with vinegar i still have a haze on the glass. any suggestions on how to get this haze.

 

[wesly2007]

any ideas at all?

 

[B-NICE]

Use lemon juice.

 

[Colleen53]

Water spots from hard water are difficult to remove. I also have used the vinegar/lemon juice solution with a scruby pad and that works, but will not get all the spots off.

 

[B-NICE]

Go up, down, and side to side with a single edge razor blade.

 

[wesly2007]

I have tried all of these and still have a haze on the glass. Anyone have any other ideas. Is it possible to buff it out or something?

 

[Ed]

I have tried all of these and still have a haze on the glass. Anyone have any other ideas. Is it possible to buff it out or something?

Hard water stains if left long enough actually etch the glass. The only way to remove it is to buff it out.

read through this thread and pay attention to pages 4 and 5. http://www.dendroboard.com/forum/parts-construction/12562-clean-glass-last-4.html

Ed