Still not a glue-up but I am definitely getting closer!
I drove down to Annapolis earlier in the week and picked up a sheet of 1/2 inch walnut plywood. I had to cut it into approximate sized pieces to get it into my car but that is pretty normal for me.
Once back I trimmed it up a little more to get it to fit in the designated locations. The walnut ply ended up being slightly thicker then the birch ply I was using as a template so I needed to make my slots and mortises slightly bigger but that was easily done with chisel or table saw. At this point its all cut to size (except the doors) and just needs to be glued. Here is how my dry fit looked:
I am on vacation for a week so nothing is going to happen till after I'm back. But my next update 'should' be a glue-up, for reals this time ;P