With some Weld-On 16, and super glue I have again fixed the acrylic cube that has given me so many woes over the years. After draining all the water, I took a control screw driver and separated the leaking edge and forced some Weld-On 16 into the edge. I then examined the edge and any bubbles in the weld i dabbed a small amount of super glue on. Yes it looks like hell if you examine it close. However, I think I have finally beat the leaking water.
My wife and I went to this expo yesterday. We got three imitators there. I am kind of surprised how much these little guys are out. They spend a lot of time in plane open sight hopping around the top and middle of the viv. I see them way more than my Auratus.
The expo was ok there was only one vendor with darts there. I guess there was supposed to be two and the other vendor had a heater malfunction that killed all its snakes. I have said this before and I will say this again....
First of all most of this will be carried over from some posts I made about six months agao on my local reef clubs forum but all this can be applied to dart fanatics that want to add moon lighting to their cages. Chances are you will not want more than a couple LEDs per enclosure but those of you that have multiple enclosures in a close proximity can use the same power source for many LEDs.
Here is what you will need to get your project started.