BOTTOM VENT
• Measure the distance on the inside of the left and right sides above the door strut.
• Repeat this for the above the retaining lip.
• Now cut two sections of the “L” shaped profile to fit each of section.
• Measure the distance from the front of the door strut to the back of the retaining lip, on the left-hand side.
• Repeat this for the right-hand side.
These measurements are used to determine final size of the Stainless Steel mesh for the vent to the correct size.
• Use masking tape to cover both sides of the stainless steel mesh (stick this wider than your measurements)
• Use a marker pen to draw out your measurements on the tape.
• Cut along these lines.
Tip: By using the masking tape, it makes it easier to draw lines in the mesh. The masking tape also reduces stray stainless steel wire splinters flying about or puncturing your hands. The finished cut is a lot neater as well.
• Check that the newly cut mesh fits over the retaining lip and door strut.
• Make any adjustments if required.
• Apply a thin but sufficient bead of silicon along the top edges of both the retaining lip and the door strut.
• Place the stainless steel mesh back into its correct position.
• The “L” profile sections are now placed over the edges
• Press the “L” profile sections with a light, but firm pressure to bed them and the stainless steel mesh into the silicon.
• Use x6 pieces of tape and stick them across the top and down the sides of the strut and lip, this will assist in keeping everything in the correct place.
